CDA HVN91 Bedienungsanleitung

Customer Care Department • The Group Ltd. • Harby Road • Langar • Nottinghamshire • NG13 9HYT : 01949 862 012 F : 01949 862 003 E : se

10• The zone display will show the total programme power level and a. (dot) and the timer will start to countdown. Once the total programme is compl

11You can have a maximum of three automatic programmes set at once: one of the left two zones, one of the central two zones and the right zone.The tim

12To cancel the timer once set• Touch the or keys simultaneously or reduce the time required using the key until the zone display shows 0.

13Use of the childlock when the hob is in useThe zone control display will alternate between showing the selected power level and the locked symbol

14Temperature LimiterThe hob is equipped with a temperature limiting sensor that adjusts the power output of the hob if the bottom of the cookware bec

15Ecient Use of your HobThe hob is equipped with zones of dierent sizes, designed to accommodate most shapes and sizes of pan. For best results, onl

16Types of residues Clean with Cleaning adviceLightCleaning sponge and soft clothWipe over the zone to be cleaned with a sponge and hot water, and the

17If your hob is not working:1. Check that the zone is switched on. 2. Check that the mains supply has not been switched o. 3. Check

18IMPORTANT - PLEASE NOTE: In the event of any breakage, crack or cracking – even minimal – of the vitroceramic glass, immediately disconnect your app

19Fitting the HobUnpacking the hob:Take care not to lose or mishandle any parts.Fitting position of the hob:This appliance must be installed a minimum

2ImportantThe CDA Group Ltd cannot be held responsible for injuries or losses caused by incorrect use or installation of this product. Please note tha

20BCBAADAir intakeAir outletVitroceramic glassPower cordrecommended) (Fig.5). If the instructions supplied with the hood dictate that the hood must be

21• If an oven is to be installed below the hob, the thermal safety system on the hob will not allow the hob to be used at the same time as a pyroly

22from the wall to the cut-out edge. The distance from the hob, when fitted, to the back wall is 50mm. If a splashback/worktop upstand is to be fitted

23Mains Electricity ConnectionWarning! this appliance must be earthedWe recommend that the appliance is connected by a qualified electrician, who is a

24Fig.7220-240 V single phase32A 16ANeutralNBrownGreen/YellowBlueBlack or greyBlueLiveLEarthNeutralNEarthBrownLiveL220-240 V single phaseNeutralNLiveL

25

26

27

Please contact our Customer Care Department for Service on the details belowCustomer Care Department • The Group Ltd. • Harby Road • Langar •

32004/108/EC. Parts intended to come into contact with food conform to 89/109/EC.IMPORTANT INFORMATION FOR CORRECT DISPOSAL OF THE PRODUCT IN ACCORDAN

4• Do not place hot lids flat on the hob top. A “suction” eect could cause damage to the hob.• Do not drag cookware across the hob top: in the lo

5Important• Do not use the hob if the glass surface is cracked or damaged to prevent the risk of electric shock. Disconnect it from the power suppl

6Cooking on InductionThe principle of induction cooking is based on magnetic eect.When you put your cookware on an induction zone and switch it on, t

7Power level Type of cooking0 Switched o1/2 For melting (butter/chocolate) or keeping food warm3/4 Keeping food hot or to heat small quantities of li

8Using your HobTo switch the zone on • Touch the key for the zone required. The zone display will flash 0 and the hob will beep to confirm the hob

9keys until the zone display shows the required power level and then touch the direct power key to set the powernlevel. The hob will beep to confirm th