Customer Care Department • The Group Ltd. • Harby Road • Langar • Nottinghamshire • NG13 9HYT : 01949 862 012 F : 01949 862 003 E : cu
10Troubleshooting If the clothes are not dry after normal drying time:- Check that the filter is clean.- Check that you used the correct heat setting.-
11InstallationDo not block the vent at the front or base of the dryer as this will impair the functioning of the appliance and could cause it to overh
12or window. The best solution is to connect the vent hose to a permanent connection through a wall or a single glazed window. This is particularly
13g. 4Reversing the DoorThe door on the dryer can be positioned either with the left or right hand hinging, as shown in figure fig.4. Please note: powe
14Electrical InformationWarning! This appliance must be earthed.The mains lead of this appliance has been fitted with a BS 1363A 13 amp fused plug. To
15As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug
16Technical Information:For electrical ratings see plate on rear of machine.Room temperature range 5˚C to 30˚C. (Drying performance decreases as room
17NOTES:
18NOTES:
19E & O E. All instructions, dimensions and illustrations are provided for guidance only. CDA reserve the right to change specifications without
2User Information The room must be adequately ventilated to avoid the backflow of gases into the room from appliances burning gas or any other fuels.
Customer Care Department • The Group Ltd. • Harby Road • Langar • Nottinghamshire • NG13 9HYT : 01949 862 012 F : 01949 862 003 E : cu
3 • Dry anything other than the recommended articles in the tumble dryer. These can cause fires. • Place articles which have been in contact with dr
4 This label positioned on the rear of your dryer, indicates the surface is hot when in operation – avoid touching.ImportantThis appliance must
5Appliance information:Please enter the details on the appliance rating plate below for reference, to assist CDA Customer Care in the event of a fault
6Use and ControlsA. The timer - turn the timer knob anticlockwise until the required programme time around the timer knob is selected.B. Heat settin
7• Select correct heat position. • Set the timer to the correct position (See programme around the timer on fascia panel).• For energy labelling
8To stop the machine in the middle of a programme, open the door: The drum will stop rotating automatically and reset when you close the door. To leng
9Care and MaintenanceCleaning The FilterThe filter is found by opening the door (fig. 2) and must always be in position when drying items in the applia
Kommentare zu diesen Handbüchern