CDA FWC620 Anleitung zur Fehlerbehebung PDF herunterladen (Seite 3)

Before ﬁrst use

You must allow the appliance to settle for at least twenty four hours prior to switching the power on.

It is recommended that you remove all internal and external packaging and clean the interior of the appliance prior to ﬁrst use,

using a solution of bicarbonate of soda and warm water and then thoroughly drying the interior.

The appliance may have an odour to it at ﬁrst use. This will disappear as the appliance cools.

Please note:

• The appliance will work continuously until it gets down to the correct temperature.

• If the appliance is switched off, you should allow ﬁve minutes before switching it on again to prevent unnecessary damage

to the compressor.

Use

• Only store wine in sealed containers

• Do not overload the cabinet

• Only open the door when necessary

• Do not cover the shelves with aluminium foil or anything else that will prevent air from circulating around the cabinet.

• To prevent damage to the door seal, ensure the door is fully open before removing the shelves.

• This appliance has been designed to work at an ambient temperature between 16º to 32ºC. Use of the appliance outside

of these parameters may cause the unit to fail.

• This is a self-defrosting appliance. The compressor will not run during the thirty minute defrost cycle.

1 2 3 4 5 6 7 8 9 10

Keine Kommentare

CDA FWC620 Anleitung zur Fehlerbehebung Seite 3