CDA hc9625 Handbuch

Customer Care Department • The Group Ltd. • Harby Road • Langar • Nottinghamshire • NG13 9HYT : 01949 862 012 F : 01949 862 003 E : se

10To adjust the power level when the booster is set:Touch for the zone required.Touch and hold or until the required power level shows on the zo

11To change the timer once set:Touch for the required zone.Touch . The remaining time for the active zone will show on the timer display.Touch o

12To go straight to 30 minutes, touch . Then touch either or to adjust the time further. If the minute minder is set, the hob will switch o aft

13Please note: If the hob has been turned o whilst the childlock is on, touch then touch and hold for approximately two seconds to switch o the

14Auto-stop Protection:The hob is equipped with a sensor that will switch o the zone after a factory set period of time if no keys are touched once t

15Ecient Use of Your HobThe hob is equipped with zones of dierent sizes, designed to accommodate most shapes and sizes of pan. For best results, on

16Choose pans which are between the sizes recommended in the table above, and with bases that are as non-reflective as possible, e.g. dull and dark.Onl

17dicult to remove.All cleaner residues should be removed with a damp cloth.Important:• Steam cleaners must not be used when cleaning this applian

18Mains Electricity ConnectionWarning! This appliance must be earthedWe recommend that the appliance is connected by a qualified electrician, who is a

19A larger cable may not fit the terminal connections.• The marking of the current rating of the fuse or circuit breaker protecting this appliance sh

2The CDA Group Ltd cannot be held responsible for injuries or losses caused by incorrect use or installation of this product. Please note that CDA re

20Wall furniture requirements:The minimum height of any cabinet immediately above the hob is 900mm. The minimum height of any adjacent units (includi

21How to Install the HobHow to install the hob:Overall dimensions of the hob: width 900mm depth 350mmWorktop cut-out dimensions: width 880mm d

223. Secure the hob to the worktop using the fixing brackets and screws supplied, as shown in (Fig. 10). Remove any excess sealant after tightenin

23NOTES:

Please contact our Customer Care Department, or for Service on the details below.Customer Care Department • The Group Ltd. • Harby Road • Lang

3IMPORTANT INFORMATION FOR CORRECT DISPOSAL OF THE PRODUCT IN ACCORDANCE WITH EC DIRECTIVE 2002/96/EC.At the end of its working life, the product must

4User InformationPlease note:• Ceramic hobs become hot and remain hot during and immediately after use. Do not touch the hob until it has been all

5Using Your HobZones:1. Front left: 1/2.2kW - 140/210mm dual2. Centre left: 1.2kW - 140mm3. Centre right: 0.7/1.7kW - 120/180mm dual4. Front r

6Touch control 1. Zone indicator key2. Zone display3. Zone indicator4. Dual zone indicator5. Dual zone key6. Increase key7. Decrease key8. Ti

7Fig. 3Hi-light cooking zone Ø 140mmSecond element Hi-light double zoneFig. 4How to Use the HobThe ceramic surface of the hob allows fast transmission

8To switch on a zone:Once the hob is switched on, touch for the zone required. The zone indicator will switch on to confirm the zone is active.EITHE

9To switch the hob o:Touch and hold at any time.Zone Settings:Booster:The hob is equipped with a booster function, which allows a zone to run at ma