CDA FWV460 Handbuch PDF herunterladen (Seite 4)

The Icemaker

Before ﬁrst use:

1. Pull the machine out of its housing by lifting the handle of the machine and pulling it towards you.

2. Fill the water tank (even if the appliance is to be plumbed in to the mains water supply).

3. Turn on the machine at the switch on the left side of the machine.

4. Push the machine back into the housing.

5. Switch on the machine by pressing the ON button.

6 The machine is now ready for use and the display shows ICE ON WATER READY.

The water tank

It is possible to use the appliance without connecting it to the mains water supply. There is an integral water tank which

can be used in this instance. To ensure the best results from your appliance, it is recommended that the water tank be

emptied frequently and reﬁlled with fresh water, and no water be left in the tank for long periods.

When the water tank is empty, the message WATER MISSING will show on the display.

To ﬁll the water tank:

1. Pull the machine out of its housing by lifting the handle of the machine and pulling it towards you.

2. Open the lid of the water tank and ﬁll it until the water is 4cm from the top level. Then close the lid.

3. Push the machine back into the housing.

Please note:

On ﬁrst use, you should run a minimum of 2.5l through the icemaker to ﬂush through the pipes in order to remove any

impurities from the system. Failure to carry out this simple procedure could cause problems or damage to the workings of

the icemaker.

You should only use cold drinking water in this appliance, with water hardness level less than 7˚F.

The water tank can be removed for cleaning, following the steps above, and then lifting it out of the machine.

1 2 3 4 5 6 7 8 9 10 11 12

Keine Kommentare

CDA FWV460 Handbuch Seite 4