CDA HCG 730 Users operating instructions Bedienungshandbuch PDF herunterladen (Seite 179)

Steps

1. Fold the PPID label around the cable.

2. Push the cable until the cable passes completely through the channel.

CAUTION: To prevent damage to the I/O cable, you must release the locking tab before

removing or installing the I/O cable from the connector on the hard-drive backplane.

3. If locked, rotate the locking tab on the I/O cable connector clockwise 90 degrees to release the lock.

4. Connect the I/O panel cable to the connector on the hard-drive backplane.

5. Rotate the locking tab on the I/O cable connector counter clockwise 90 degrees to secure the lock.

6. Tighten the screws to secure the control panel to the chassis.

NOTE: You must route the cable properly to prevent it from being pinched or crimped.

Next steps

Follow the procedure listed in After working inside your system.

179

1 2 ... 174 175 176 177 178 179 180 181 182 183 184 ... 207 208

Keine Kommentare

CDA HCG 730 Users operating instructions Bedienungshandbuch Seite 179