CDA HG7300 Wartungshandbuch PDF herunterladen (Seite 14)

Installation

Technical Information for the Installer

In order to install the hob into the kitchen fixture, a hole with the dimensions shown in fig. 12 has to be made,

bearing in mind the following:

– Within the unit, between the bottom of the hob and the upper surface of a shelf there must be a clearance of at

least 30mm.

– It is absolutely essential that you place a separator between the base of the hob and the built-in unit or the oven.

– The hob must be kept no less than 200mm away from any side wall (fig. 12).

– The hob must be installed at least 60mm from the wall.

– If a splashback is to be fitted it has

to be fireproof and heat resistant; it

is important to ensure that the gap

between the edge of the hob and the

splashback is at least 50mm. Refer to

the instructions provided with your

splashback for further information.

– There must be a distance of at least

650mm between the hob and any

wall cupboard or extractor hood

positioned immediately above (see

fig. 14).

– If the hob is installed over a built-

in oven, there must be a distance

of at least 30mm between the two

appliances. The two appliances

should be connected to the gas supply

with independent connections

Installation in Kitchen Cabinet with Door

It is recommended that a 30mm clearance be

left between the cooktop and the fixture surface

(fig. 13).

650 mm

450 mm

480

–2

560

200

–2

680

500

30 mm

Space for

connections

Clearance

Door

Fig. 12

Fig. 14Fig. 13

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 23 24

Kommentare zu diesen Handbüchern

Keine Kommentare

CDA HG7300 Wartungshandbuch Seite 14

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Kochfelder CDA HG7300