CDA fwc603 Anleitung zur Fehlerbehebung PDF herunterladen (Seite 9)

Installing the Wine Cooler

This appliance is intended to be installed in a space

between two units.

The minimum space required is:

fwc152 – 150 mm wide x 555 mm deep x 825 mm high

fwc303 – 300 mm wide x 580 mm deep x 825 mm high

fwc603 – 600 mm wide x 580 mm deep x 825 mm high

fwc623 – 600 mm wide x 580 mm deep x 825 mm high

Please note: When the product is installed, there should

be a small ventilation gap between the top of the unit

and the underside of the worktop (6 mm or ¼”)

These products should not be installed:

1. In direct sunlight.

2. Adjacent to a heat source (oven or radiator).

3. Below a hob unit.

4. Where a continuous plinth is to be used, it is necessary

cut a section out so that the ventilation slots at the

front of the appliance are not obstructed in any way g 6.

IMPORTANT: Failure to follow the instructions regarding

installation and ventilation may invalidate the warranty

supplied with your appliance.

To Install the Handle

IMPORTANT: Do not overtighten the screws, and do not use power tools to install the handle.

1. Carefully locate the handle over the xing pins.

2. Using the supplied allen key, tighten the securing grub screw to x the handle.

IMPORTANT: Take care when installing the handle not to damage the door. Any damage caused may not be covered

by the warranty supplied with your appliance.

g. 6

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Keine Kommentare

CDA fwc603 Anleitung zur Fehlerbehebung Seite 9