CDA CD 60 Betriebsanweisung Seite 12

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 40
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 11
Configuring the Board PCI CD/CDa Configurable DMA Interface User’s Guide
8 EDT, Inc. May 2007
2. At the prompt, press Enter to confirm the loading operation. (If the file date is older than the PROM
ID date, you may need to press Enter twice.)
The board reloads the firmware from the PROM only during power-up, so after running
pciload, the
old firmware remains in the PCI FPGA until the system has power-cycled.
NOTE Updating the firmware requires cycling power, not simply rebooting.
For a list of all
pciload options, enter:
pciload --help
Loading the UI FPGA Firmware and Configuring the PCI CD/CDa
The utility initpcd loads the UI FPGA configuration files, programs the registers, sets the clocks (if
necessary), and gets the PCI CD/CDa mezzanine board ready to perform DMA. This utility takes, as
an argument, a software initialization file, and then automatically runs the pertinent commands.
If you use
initpcd to configure the PCI CD/CDa, your application can concern itself solely with
performing DMA and other application-specific operations; it will therefore omit PCI CD/CDa-specific
operations and be portable to other EDT boards that peform DMA.
To configure the PCI CD/CDa, enter:
initpcd -u unit_number -f pcd_config/filename.cfg
replacing unit_number with the number of the board (by default, 0), and replacing
filename with
one of the initialization files listed in About the Software and Firmware; for example:
initpcd -f
pcda.cfg
NOTE Software initialization files are editable text files. If the files provided don’t meet your needs, copy
and modify the one that’s closest to your required configuration, then run
initpcd with your new
file.
Using Custom FPGA Configuration Files
You can substitute your own FPGA configuration file, if necessary. If you wish to develop your own
VHDL design, contact EDT. When you’re done, be sure to create a new software initialization file for
your new firmware file and update the
pcd_config directory to include it.
Seitenansicht 11
1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 39 40

Kommentare zu diesen Handbüchern

Keine Kommentare